Analyze The Know-how Of Slurry Pump Operation
The slurry pump is mainly used for conveying, and the conveying efficiency depends on the operation effect of the slurry pump. The slurry pump works well, and the conveying efficiency is high. If not, the conveying efficiency will be mediocre.
How to improve the operation efficiency of the slurry pump? To ensure the efficient operation of the slurry pump, the gap between the impeller of the slurry pump and the front guard plate must be adjusted in time. The gap between the impeller of the metal-lined pump and the front guard plate is between 0.5-1mm. The gap between the impeller of the lining pump and the front and rear sheaths should be equal.
When adjusting the clearance of the slurry pump impeller, first stop the pump, loosen the bolts that press the bearing assembly, and tighten the nut on the adjusting bolt to move the bearing assembly forward. At the same time, turn the shaft by hand to rotate in the direction of the pump rotation until the slurry pump impeller Until it rubs against the front guard plate. For metal-lined pumps, loosen the nut just tightened in the front by half a turn. Then tighten the front nut on the adjusting bolt to move the bearing assembly back. At this time, the gap between the impeller and the front guard plate is 0.5-1mm. For the rubber lined pump, tighten the nut on the adjusting bolt to make the slurry pump bearing assembly move first. Move forward so that the impeller is in contact with the front sheath, and when the bearing assembly is moved backward, the impeller is in contact with the rear sheath, and the total movement distance of the slurry pump of the bearing assembly is measured. This distance is generally taken as the distance between the impeller and the front and rear sheaths. For the clearance, adjust the position of the bearing assembly with the adjusting bolt to ensure the correct clearance value between the impeller and the front and rear sheaths.
After adjustment, before restarting, check whether the slurry pump impeller rotates normally, whether the bearing assembly compression bolts and adjusting bolts are tightened, and then start the slurry pump.







