Method for water diversion and exhaust of slurry pump

What is the method of diverting water and exhausting the slurry pump? The following editor will give you an introduction.

1. Install valves at the inlet and outlet to fill water

This method is to install a valve on the inlet pipe of the slurry pump, and connect the water pipe to fill the pump with water. This is a commonly used and simpler method.

2. Fill water with a hand pump

Some slurry pumps have their own hand pumps, or you can purchase or make your own small hand pumps. Install a gate valve at the water inlet. After closing the valve, fill the water press with a small amount of water to divert water. After the hand pump is discharged, it means that the pump is full of water and can be turned on.

3. Use vacuum equipment to exhaust and fill water

The self-exhausting of the centrifugal pump is the same as the vacuum pumping negative pressure exhaust, so the water ring vacuum pump is used to exhaust the water to fill and divert water.