Causes of cavitation in slurry pump

What are the causes of cavitation in the slurry pump? The following editor will give you an introduction.

1. Operation in cavitation state

Slurry pump running in the cavitation state will cause the pump to vibrate and noise, and it will also greatly reduce the life of the pump.

2. Insufficient pump output due to cavitation of the slurry pump

Insufficient pump output means that both the head and flow rate reach the indicators that the pump should achieve. There are two reasons for this phenomenon. When designing the conveying system, the relationship between cavitation characteristics is not fully considered. If the critical cavitation flow rate is less than the required flow rate, the slag When the slurry pump is in operation, cavitation occurs at the critical cavitation flow rate, which greatly reduces the lift of the slurry pump and causes insufficient output. The solution to this problem is to change the piping system or replace with a better cavitation performance. The pump makes the cavitation allowance of the pipeline installation greater than the required cavitation allowance of the pump at the required flow rate.

3. The blockage of the suction pipeline causes cavitation of the slurry pump

Blockage of the suction pipeline of the slurry pump can easily cause cavitation of the pump, and will also cause insufficient pump output. Reasons: large particles or long fiber materials block the pipeline inlet, impeller inlet, filter inlet and pump inlet valve are damaged and cannot be opened completely. Solution: Clear blockages and repair pump inlet valves.


You Might Also Like

Send Inquiry