Repairing method for the abrasion of slurry pump casing
In the long-term use of the slurry pump, due to external environmental factors, the pump casing may be worn out, so how to repair it? The following editor will give you an introduction.
1. Before repairing the worn parts of the pump casing, the impeller of the slurry pump needs to be dismantled, leaving room for operation, and doing a good job of dust prevention and safety protection on site.
2. Observe the severity of the pump casing wear first, and then consider which way to repair it.
3. Perform pre-welding where there is leakage in the slurry pump, strengthen the leakage points and weak points, and then use a large amount of clean water to rinse the pump casing to remove the remaining paint on the surface.
4. Finally, sandblast the surface of the pump casing to remove the oxide layer, increase the surface roughness of the pump casing repair, and increase the bonding force of the repair material.
5. When repairing the slurry pump casing, use good materials for spraying, clean the surface before the spectrum, and then start spraying.
6. When spraying paint, it must be painted correctly according to a certain proportion.
7. After the repair is completed, a second repair will be carried out to achieve the effect of no defects on the surface of the entire protective layer.
8. After the repair is completed, it is cured by heating, so that the performance of the repair material can be fully displayed.







