How to maintain bearings for slurry pumps

What is the method of maintaining the bearings of the slurry pump? The following editor will give you an introduction.

1. It is recommended to use carbon fiber impregnated PTFE or butter boiled cotton thread filler. When the working pressure is not more than 0.5MP a, asbestos filler can be used.

2. Keep it clean, dry, oil-free and leak-free.

3. Daily check whether the oil level in the bracket is appropriate. The correct oil level is near the oil level line and should not exceed ±2mm.

4. Frequently check whether the pump is running abnormally in sound, vibration or leakage, and deal with it promptly if any problems are found.

5. It is strictly forbidden to run the pump in the evacuated state, because the pump runs in the evacuated state not only vibrates severely, but also affects the life of the pump, so special attention must be paid to it.

6. Metal objects and large solids exceeding the allowable passage of the pump are strictly prohibited from entering the pump, and flexible materials such as rubber, cotton thread, and plastic cloth are strictly prohibited to enter the pump, so as not to damage the flow parts and block the impeller flow path, so that the pump cannot work normally.

7. Frequently check whether the pressure and flow of the shaft seal water and cooling water are appropriate. Check the opening of the shaft seal water pipe valve or detect the temperature of the stuffing box. When the temperature is high, the water supply is insufficient. For pumps that use grease to lubricate the packing, add oil regularly once or twice a day to ensure that the packing is in a good lubrication state.

8. Regularly check the leakage of the shaft seal water. When the leakage increases, the bolts of the packing gland should be adjusted, and the packing should be replaced in time.


You Might Also Like

Send Inquiry