Reasons for excessive power consumption of slurry pumps

What are the reasons for the excessive power consumption of the slurry pump? The following editor will give you an introduction.

1. There is friction between rotor parts and stator parts.

2. The viscosity of the conveyed liquid becomes larger.

3. The speed of the slurry pump becomes higher.

4. The specific gravity of the conveyed liquid exceeds the original design value.

5. The size of the impeller of the water pump is too large.

6. The resistance of the pipeline system exceeds or falls short of the predetermined value.

7. There is friction between rotor parts and stator parts.

8. The flow rate of the slurry pump is too large.

9. The mechanical seal exerts too much pressure on the seal seat, and the bearing is worn or damaged.

10. The head of the slurry pump is too low and the flow is too large.