Causes of impeller wear when using slurry pumps and precautions during processing
What are the reasons for impeller wear when using a slurry pump and the precautions for processing? The following editor will give you an introduction.
1) Reasons for wear of slurry pump impeller:
1. The properties of slag and solids in slag.
2. The movement characteristics of the solid-liquid two-phase in the pump, that is, the contact mode of the solid-liquid and liquid phase with the surface of the flow path components.
3. The material properties of the flow channel components of the pump.
2) Matters needing attention when processing slurry pump impeller
1. When rotating the impeller, the gap between the machine tool, the tool post and the tool post should be adjusted to the smallest possible position to ensure that the entire machine tool processing system has sufficient rigidity. The chamfer of the workpiece should be as large as possible so that the tip of the turning tool can be smoothly cut in and out during the turning process, so as to minimize the impact to the tip of the tool and the crack of the workpiece.
2. A reasonable geometric angle of the cutter is beneficial to improve the durability of the slurry pump. The grinding wheel should be stable and sharp during the grinding process, and the saw blade should be ground into a straight line without saw teeth.







